HVAC/Climate controls

Overview

Climate are representations of KNX HVAC/Climate controls.

Example

climate = Climate(
    xknx,
    'TestClimate',
    group_address_temperature='1/2/2',
    group_address_setpoint='1/2/3',
    group_address_operation_mode='1/2/4')

# Setting basis setpoint to 23 degrees.
await climate.set_setpoint(23)))
# Reading climate device
await climate.sync()
print("Current temperature: ", climate.temperature)

Configuration via xknx.yaml

Switches are usually configured via xknx.yaml:

groups:
    climate:
        Children.Climate: {group_address_temperature: '1/7/2', group_address_setpoint: '1/7/3', group_address_target_temperature: '1/7/4'}
        Office.Climate: {group_address_temperature: '1/7/5', group_address_operation_mode: '1/7/6'}
        Attic.Climate: {group_address_temperature: '1/7/7', group_address_operation_mode_protection: '1/7/8', group_address_operation_mode_night: '1/7/9', group_address_operation_mode_comfort: '1/7/10'}

• group_address_temperature KNX address of current room temperature
• group_address_setpoint KNX address of basis setpoint.
• group_address_target_temperature KNX address for reading the target temperature from KNX bus.

• group_address_operation_mode KNX address for operation mode.

• group_address_operation_mode_protection KNX address for switching on/off frost/heat protection mode.
• group_address_operation_mode_night KNX address for switching on/off night nmode.
• group_address_operation_mode_comfort KNX address for switching on/off comfort mode.

group_address_operation_mode_protection / group_address_operation_mode_night / group_address_operation_mode_comfort are not necessary if group_address_operation_mode was specified.